Welcome to the bigboi Knowledge Base

Your Source for Expert Advice, Troubleshooting, and Product Information

WashR FLO Output pressure varies high and low

POSSIBLE CAUSES 

SOLUTION

Not enough inlet water supply Turn water onto full force. Check garden hose for kinks, leaks or blockage
Pump is sucking air  Check that the hose and hittings are air tight. Turn off the machine and purge pump by squeezing trigger gun until a steady flow of water emerges through the nozzle
Water inlet filter is clogged  Remove filter and rinse out with a fine needle
Calcified gun, hose or spray wand Run distilled vinegar through detergent tank
Discharge nozzle is obstructed  Blow out or remove debris with a fine needle 

Updated on 25 Jun 2024